How to maintain and upkeep the flat labeling machine in summer is an important p

How to maintain and upkeep the flat labeling machine in summer is an important part of production. Only by ensuring the normal operation of the equipment can production efficiency be guaranteed. To maintain the normal operation of the equipment, reasonable maintenance is essential. Taking the flat labeling machine as an example, with the arrival of the scorching summer, how can we do a good job in the maintenance and upkeep of the flat labeling machine?

1. Lubrication of flat labeling machine.

We should regularly lubricate the linkage and bearing parts of the double-sided labeling machine. If the equipment is not lubricated for a long time during operation, it will accelerate the wear of the equipment, resulting in insufficient precision of the parts and affecting the effectiveness and service life of the equipment. In hot summer weather, the lubrication time is about twice as long as in spring and autumn. If the temperature is high, add oil appropriately. After adding oil, if the temperature is slightly high and then slowly drops off, it proves that the lubrication is effective.

2. In addition to lubrication, we also need to do a good job of dust removal and cleaning on the mechanical part of the double-sided labeling machine. How should we operate it specifically

Firstly, the body of the labeling machine is made of stainless steel and aluminum. During the wiping process, we should try to choose soft materials as much as possible, because once hard or rough materials are used, they can easily scratch the surface of the machine, affecting its appearance. Moreover, it is not suitable for cleaning after a long time. If it is used in the food industry, it will inevitably cause hygiene hazards.

3. In terms of electrical appliances, the flat labeling machine has slightly more electrical appliances compared to ordinary labeling machines, so we need to pay attention to regular maintenance in summer. It's better to check if the wire end is loose. When we have time, we suddenly realize that the machine cannot operate. We spent a long time looking up and down, but couldn't find the problem. Finally, we found out that it was on a small wire end, which affected production and was not worth it.